FlexRouter II

The depaneling systems FlexRouter II are developed for inline operations in productions with middle to high mix.
Due to its short cycle time and high flexibility, this depaneling system is predestined for the automatic separation of circuit boards.
The user-friendly graphic interface allows a quick and simple adaption in the start-up process or for product changes.

Key features

• High speed, low stress separating process
• Automatic change-over within less than 30 seconds
• Flexible servogripper with 100mm stroke
• Automatic position correction with fiducial measurement
• Small footprint with 1000 mm cell width
• Multi level use of router bits for increase of lifetime
• Automatic router bit exchange and rejection of worn out bits
• Intuitive and user friendly HMI (TS1)

Options

• Edge belt, Flat belt, shuttle systems or trayloader for outfeed
• Router bit diameter and height check
• Pass/Fail board sorting onto NIO flatbelt or box
• 1D/2D Code Reader
• Gripper finger magazine for up to 5 pairs
• Crash Detection for gripper fingers
• AOI system for measurement of cut quality
• Handling of frameless panels or panels with frame stripes